![]() ![]() PermaLock fastener to eliminate nut and bolt failure (view larger).The Channellock 9-1/2-inch Double Tongue and Groove Plier (model 440) features a parrot nose design thats ideal for round surfaces. Use caution when using torch and handling pliers during the heating process. Channellock 410 1-1/8-Inch Jaw Capacity 9-1/2-Inch Double Tongue and Groove Plier. Tightly wrap over the paracord with hockey tape.Įnsure to use proper personal safety equipment at all times. Spiral wrap the handles with paracord, ensuring to leave space for the working ends. Screwdriver side will have a flat edge while the key tool side will be more rounded.ħ. Screwdriver side will finish at 3/16” wide and 1/16” thick and the key tool side will gradually taper to 1/8” wide and 1/8” thick. Channellock 420CB Tongue and Groove Pliers, 9. Using a grinder, roughly shape both ends of the pliers. Pull the pliers down towards you so the bend ends up being at a 90 degree angle. While it is still hot, place the long handle in the vice at the 1” mark making sure the open side of the jaws are facing you. Use the finishing sandpaper to smooth out and rough or sharp edges.ģ. 1” down and heat that area around the mark until red hot.Ħ. Use the Dremel tool to acquire finished dimensions and to smooth out the rough grinding spots.Ģ. Start by removing the pliers from the packaging and cutting off the grips with a sharp knife.ĥ. Safety Equipment -Channel Lock 420 Pliers -Knife -Grinder (Bench or Angle) -Torch (We used propane)ĭremel Kit Bench Vice 550 Paracord Finishing Sandpaper Hockey Tapeġ. Modified Channel Locks A Start to Finish Guide Materials Needed ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |